User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 4 Modes
NBG-418N v2 User’s Guide
42
4.5 Se tting your NBG- 418N v2 to Clie nt Bridg e Mode
1 Connect your computer to the LAN port of the NBG-418N v2.
2 The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode and 192.168.1.2 by default in
non-router mode.
3 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type the
IP address of the NBG-418N v2 as the web address in your web browser.
4 Log into the Web Configurator. See the
Chapter 2 on page 16 for instructions on how to do this.
5 Go to Ma inte na nc e > Sys OP Mode > Ge ne ral and select Clie nt Bridg e .
WLAN AP Select Use this screen to choose an access point that you want the NBG-418N v2 to
connect to. You should know the security settings of the target AP.
General Use this screen to configure wireless LAN.
MAC Filter Use the MAC filter screen to configure the NBG-418N v2 to block access to
devices or block the devices from accessing the NBG-418N v2.
Advanced This screen allows you to configure advanced wireless settings.
WPS Use this screen to configure WPS.
WPS Station Use this screen to add a wireless station using WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled.
MBSSID Use this screen to configure multiple SSIDs on the NBG-418N v2.
LAN IP Use this screen to configure LAN IP address and subnet mask.
Maintenance
System General Use this screen to view and change administrative settings such as system
and domain names, password and inactivity timer.
Time Setting Use this screen to change your NBG-418N v2’s time and date.
Logs View Log Use this screen to view the logs for the categories that you selected.
Tools Firmware Use this screen to upload firmware to your NBG-418N v2.
Configuration Use this screen to backup and restore the configuration or reset the factory
defaults to your NBG-418N v2.
Restart This screen allows you to reboot the NBG-418N v2 without turning the power
off.
Sys OP Mode General This screen allows you to select the device operating mode: Ro ute r, Ac c e ss
Point, Unive rsal Re pe a te r or C lie nt Bridg e .
Language Language This screen allows you to select the language you prefer.
Table 15 Menu: Universal Repeater Mode (continued)
LINK TAB FUNCTION