User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 4 Modes
NBG-418N v2 User’s Guide
39
4.4 Se tting your NBG- 418N v2 to Unive rsa l Re pe a te r Mode
1 Connect your computer to the LAN port of the NBG-418N v2.
2 The default LAN IP address of the NBG-418N v2 is 192.168.1.1 in router mode and 192.168.1.2 by default in
non-router mode.
3 After you’ve set your computer’s IP address, open a web browser such as Internet Explorer and type the
IP address of the NBG-418N v2 as the web address in your web browser.
4 Log into the Web Configurator. See the
Chapter 2 on page 16 for instructions on how to do this.
5 Go to Ma inte na nc e > Sys OP Mode > Ge ne ral and select Unive rsal Re pe ate r.
6 A pop-up window appears providing information on this mode. Click OK in the pop-up message
window. Click Apply. Your NBG-418N v2 is now in Unive rsal Re pe ate r mode.
Note: Wait while the NBG-418N v2 restarts, then log in to the Web Configurator again.
4.4.1 Sta tus Sc re e n (Unive rsal Re pe a te r Mode )
Click on Sta tus. The screen below shows the status screen in Unive rsal Re pe a te r mode.
Tools Firmware Use this screen to upload firmware to your NBG-418N v2.
Configuration Use this screen to backup and restore the configuration or reset the factory
defaults to your NBG-418N v2.
Restart This screen allows you to reboot the NBG-418N v2 without turning the power
off.
Sys OP Mode General This screen allows you to select the device operating mode: Ro ute r, Ac c e ss
Point, Unive rsal Re pe a te r or Clie nt Bridge .
Language Language This screen allows you to select the language you prefer.
Table 13 Menu: AP Mode (continued)
LINK TAB FUNCTION