User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 2 The Web Configurator
NBG-418N v2 User’s Guide
18
Fig ure 6 Selecting the setup mode
2.3 Re se tting the NBG- 418N v2
If you forget your password or IP address, or you cannot access the Web Configurator, you will need to
use the WPS/ RESET button at the back of the NBG-418N v2 to reload the factory-default configuration
file. This means that you will lose all configurations that you had previously saved, the username will be
reset to admin and password will be reset to 1234. The IP address will be reset to “192.168.1.1”.
Make sure the power LED is on and press the WPS/ RESET button for longer than 10 seconds to restart/
reboot and set the NBG-418N v2 back to its factory-default configurations.