User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 23 Troubleshooting
NBG-418N v2 User’s Guide
153
23.5 Wire le ss Proble ms
I cannot access the NBG-418N v2 or ping any computer from the WLAN.
1 Make sure the wireless LAN is enabled on the NBG-418N v2.
2 Make sure the wireless adapter on the wireless station is working properly.
3 Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports the
same wireless standard as the NBG-418N v2.
4 Make sure your computer (with a wireless adapter installed) is within the transmission range of the NBG-
418N v2.
5 Check that both the NBG-418N v2 and your wireless station are using the same wireless and wireless
security settings.
6 Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the NBG-418N v2.
7 Make sure you allow the NBG-418N v2 to be remotely accessed through the WLAN interface. Check
your remote management settings.
•See
Chapter 6 Wireless LAN for more information.
I cannot access the Web Configurator after I switched to a non-router mode.
When you change from router mode to a non-router mode, you must manually give your computer an
IP address in the range between 192.168.1.3 and 192.168.1.254 as non-router mode has no LAN DHCP
server.
Refer to
Appendix D on page 178 for instructions on how to change your computer’s IP address.