User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 23 Troubleshooting
NBG-418N v2 User’s Guide
152
1 Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide and Section 1.3 on page 13.
2 Reboot the NBG-418N v2.
3 If the problem continues, contact your ISP.
The Internet connection is slow or intermittent.
1 There might be a lot of traffic on the network. Look at the LEDs, and check Section 1.3 on page 13. If the
NBG-418N v2 is sending or receiving a lot of information, try closing some programs that use the Internet,
especially peer-to-peer applications.
2 Check the signal strength. If the signal strength is low, try moving the NBG-418N v2 closer to the AP if
possible, and look around to see if there are any devices that might be interfering with the wireless
network (for example, microwaves, other wireless networks, and so on).
3 Reboot the NBG-418N v2.
4 If the problem continues, contact the network administrator or vendor, or try one of the advanced
suggestions.
23.4 Re se tting the NBG- 418N v2 to Its Fa c tory De fa ults
If you reset the NBG-418N v2, you lose all of the changes you have made. The NBG-418N v2 re-loads its
default settings, and the username/password resets to a dmin/1234. You have to make all of your
changes again.
You will lose all of your changes when you push the WPS/ RESET button.
To reset the NBG-418N v2,
1 Make sure the power LED is on.
2 Press the WPS/ RESET button for longer than 10 second to reboot and restore factory-default
configurations on the NBG-418N v2.
If the NBG-418N v2 restarts automatically, wait for the NBG-418N v2 to finish restarting, and log in to the
Web Configurator. The username is a dm in and password is 1234.
If the NBG-418N v2 does not restart automatically, disconnect and reconnect the NBG-418N v2’s power.
Then, follow the directions above again.