User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 20 Tools
NBG-418N v2 User’s Guide
144
Fig ure 109 Configuration Restore Successful
The NBG-418N v2 automatically restarts in this time causing a temporary network disconnect. In some
operating systems, you may see the following icon on your desktop.
Fig ure 110 Temporarily Disconnected
If you uploaded the default configuration file you may need to change the IP address of your computer
to be in the same subnet as that of the default NBG-418N v2 IP address (192.168.1.1 in router mode). See
Appendix D on page 178 for details on how to set up your computer’s IP address.
If the upload was not successful, the following screen will appear. Click Re turn to go back to the
Co nfig uration screen.
Fig ure 111 Configuration Restore Error
20.4.3 Ba c k to Fa c tory De fa ults
Pressing the Re se t to de fa ult button in this section clears all user-entered configuration information and
returns the NBG-418N v2 to its factory defaults.
You can also press the WPS/ RESET button on the rear panel to reset the factory defaults of your NBG-
418N v2. Refer to
Section 1.4.1 on page 14 for more information on the WPS/ RESET button.
20.5 Re sta rt Sc re e n
System restart allows you to reboot the NBG-418N v2 without turning the power off.
Click Mainte na nc e > Tools > Re sta rt. Click Re sta rt to have the NBG-418N v2 reboot. This does not affect
the NBG-418N v2's configuration.