User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 17 Bandwidth MGMT
NBG-418N v2 User’s Guide
134
The following table describes the labels in this screen.
17.5 Adva nc e d Sc re e n
Use this screen to set up the QoS rules for the NBG-418N v2. Click Ma na g e me nt > Ba ndwidth MG MT >
Adva nc e d. The following screen displays.
Fig ure 100 Management > Bandwidth MGMT > Advanced
The following table describes the labels in this screen.
Table 58 Management > Bandwidth MGMT > Bandwidth MGMT
LABEL DESCRIPTION
Service Management
Enable Bandwidth
Management
Click the Ena ble Ba ndwidth Ma na g e me nt check box to activate the bandwidth
management feature in the NBG-418N v2.
Apply Click Apply to save your changes in t his screen.
Reset Click Re se t to begin configuring this screen afresh.
Table 59 Management > Bandwidth MGMT > Advanced
LABEL DESCRIPTION
QoS Setup
Total Bandwidth (0,
Unlimited)
This field shows the maximum number of data in kbps the NBG-418N v2 is allowed to send out
and allowed to come in through a source interface.
Up Stream Type the Up Stream or maximum outgoing transmission data rate (kbps) that is allowed to go
through the source interface on the NBG-418N v2.
Down Stream Type the Down Stre a m or maximum incoming transmission data rate (kbps) that is allowed to
go through the source interface on the NBG-418N v2.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Re se t to begin configuring this screen afresh.
QoS Rules
# This field shows the index number of the QoS rule.
Source IP Address This field shows the source IP Address of the data traffic.
Max Bandwidth(kpbs)
Up Ceiling This field shows the maximum outgoing transmission data rate (kbps) that is allo wed to go
through the source interface on the NBG-418N v2.