User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
Chapter 1 Introduction
NBG-418N v2 User’s Guide
13
1.3 LEDs
Fig ure 2 Front Panel
The following table describes the LEDs and the WPS button.
1.4 The WPS/ RESET Button
Your NBG-418N v2 supports WiFi Protected Setup (WPS), which is an easy way to set up a secure wireless
network. WPS is an industry standard specification, defined by the Wi-Fi Alliance.
WPS allows you to quickly set up a wireless network with strong security, without having to configure
security settings manually. Each WPS connection works between two devices. Both devices must
support WPS (check each device’s documentation to make sure).
Table 1 Front Panel LEDs and WPS Button
LED CO LOR STATUS DESCRIPTION
POWER Green On The NBG-418N v2 is receiving power and functioning properly.
Off The NBG-418N v2 is not receiving power.
WAN Green On The NBG-418N v2 has a successful 10/100MB WAN connection.
Blinking The NBG-418N v2 is sending/receiving data through the WAN.
Off The WAN connection is not ready, or has failed.
WLAN Green On The NBG-418N v2 is ready, but is not sending/receiving data through
the wireless LAN.
Blinking The NBG-418N v2 is sending/receiving data through the wireless LAN.
The NBG-418N v2 is negotiating a WPS connection with a wireless
client.
Off The wireless LAN is not ready or has failed.
WPS Green On WPS status is configured.
Blinking The NBG-418N v2 is negotiating a WPS connection with a wireless
client.
Off The WPS status is not configured or disabled.