User Manual
Table Of Contents
- NBG-418N v2
- User’s Guide
- Introduction
- The Web Configurator
- Connection Wizard
- Modes
- Tutorials
- 5.1 Overview
- 5.2 How to Connect to the Internet from an AP
- 5.3 Configure Wireless Security Using WPS on both your NBG-418N v2 and Wireless Client
- 5.4 Enable and Configure Wireless Security without WPS on your NBG-418N v2
- 5.5 Using Multiple SSIDs on the NBG-418N v2
- 5.6 Installing UPnP in Windows 7 Example
- 5.7 Using Bandwidth Management on the NBG-418N v2
- Technical Reference
- Wireless LAN
- WAN
- LAN
- DHCP Server
- Network Address Translation
- Dynamic DNS
- Static Route
- Firewall
- Content Filter
- Remote Management
- Universal Plug-and-Play (UPnP)
- Bandwidth MGMT
- System
- Logs
- Tools
- Sys OP Mode
- Language
- Troubleshooting
- Customer Support
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Setting Up Your Computer’s IP Address
- Wireless LANs
- Common Services
- Legal Information
- Index
NBG-418N v2 User’s Guide
114
C HAPTER 12
Sta tic Route
12.1 Ove rvie w
This chapter shows you how to configure static routes for your NBG-418N v2.
The NBG-418N v2 usually uses the default gateway to route outbound traffic from computers on the LAN
to the Internet. To have the NBG-418N v2 send data to devices not reachable through the default
gateway, use static routes.
For example, the next figure shows a computer (A) connected to the NBG-418N v2’s LAN interface. The
NBG-418N v2 routes most traffic from A to the Internet through the NBG-418N v2’s default gateway (R1).
You create one static route to connect to services offered by your ISP behind router R2. You create
another static route to communicate with a separate network behind a router R3 connected to the
LAN.
Fig ure 82 Example of Static Routing Topology
12.2 IP Sta tic Route Sc re e n
Click Ne twork > Static Route to open the Sta tic Route screen.
WAN
R1
R2
A
R3
LAN