Operation Manual

Chapter 3 The ENCRYPT Button

NBG318S User’s Guide

Figure 5 ENCRYPT Connection Procedure

press 2 seconds

within 2

minutes

5 Repeat step 4 in this section for the other powerline device you wish to connect. This

must be done within 120 seconds of pressing the ENCRYPT button on the NBG318S.

6 Check the lights on the two powerline devices. Wait for about one minute while your

powerline devices connect. The HomePlug (

) lights on both devices turn on when the

connection is made.

V If the HomePlug ( ) lights on both powerline devices do not light up, the

powerline devices are not connected. Repeat steps 3, 4 and 5 in this

section. If that doesn’t work, see the Troubleshooting in Section 26.7 on page

235 for suggestions.

7 To add more powerline devices to your network, press the ENCRYPT button on device

C (shown below) for more than 10 seconds until the HomePlug (

) light flashes.

8 Then repeat steps 4 and 5 in this section using any powerline device (A or B) you have

connected using ENCRYPT and the powerline device you want to connect (C). You

must use the ENCRYPT button on both devices.

Figure 6 Adding More Powerline Adapters to Your Network