Operation Manual

Chapter 24 Sys Op Mode
NBG318S User’s Guide
224
Figure 132 System Operation Mode: Access Point
The figure below shows a network connecting to the Internet through a HomePlug connection.
Select Router(HomePlug WAN) in the screen if you connect to the Internet as shown in the
diagram.
Figure 133 System Operation Mode: HomePlug WAN
The following table describes the labels in the screen.
Table 100 Maintenance > Sys OP Mode > General
LABEL DESCRIPTION
System Operation Mode
Router
(Ethernet
WAN)
Select this option if you connect to the Internet through a DSL or cable connection. In
this mode three of the four ports are LAN ports, the other is a WAN port.
Access Point Select this option if you connect to the Internet through a device such as a router
which allocates IP addresses. In this mode all four of your ports operate as LAN
ports.
Router
(HomePlug
WAN)
Select this option if you connect to the Internet through a DSL or cable modem
connected to your HomePlug AV network. In this mode all four of your ports operate
as LAN ports.
Apply Click this button to apply your settings.
Reset Click this button to reset your settings to the default (Ethernet WAN)