Operation Manual

Chapter 7 Wireless LAN
NBG318S User’s Guide
103
7.10 WPS Station Screen
Use this screen to set up a WPS connection using the Push Button Configuration (PBC)
method. You can use the push-button in the screen below or the external push-button on the
side of your device, if it has one. See
Section 2.2 on page 37 for instructions on using WPS
using the external WPS button.
You can also use this screen to set up a WPS connection using the PIN of another WPS-
enabled device. See
Section 7.4.1 on page 85 for instructions on using WPS with a PIN.
Click Network > Wireless LAN > WPS Station for the following screen to display.
Figure 56 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Table 36 Network > Wireless LAN > WPS
LABEL DESCRIPTION
Push Button Click this button to begin the WPS process. You have two minutes
to press the button on the device you wish to connect with. This
button may either be a physical button on the outside of device, or a
menu button similar to the Push Button button on this screen.
Or input station’s PIN number Type the PIN of the device that you are setting up a WPS
connection with. You can find the PIN either on the outside of the
device, or by checking the device’s settings. Click Start to begin the
WPS procedure.
Apply Click this to save your changes to the NBG318S.
Refresh Click this to reload the information in this screen.
Table 35 Network > Wireless LAN > WPS
LABEL DESCRIPTION