User Manual

Chapter 12 Routing
LTE3301 Series User’s Guide
99
Fig ure 64 Network > Routing > Static Route
The following table describes the labels in this screen.
12.2.1 Add/ Edit Sta tic Ro ute
Click the Add Sta tic Ro ute button or a rule’s Edit icon in the Sta tic Route screen. Use this screen to
configure the required information for a static route.
Fig ure 65 Network > Routing > Static Route: Add/Edit
The following table describes the labels in this screen.
Table 42 Network > Routing > Static Route
LABEL DESCRIPTIO N
Add Static Route Click this to create a new rule.
# This is the number of an individual static route.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Destination This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same network
segment as the device's LAN or WAN port. The gateway helps forward packets to their
destinations.
Modify Click the Edit icon to open a screen where you can modify an existing rule.
Click the De le te icon to remove a rule from the LTE3301.
Table 43 Network > Routing > Static Route: Add/Edit
LABEL DESC RIPTION
Static Route Select to enable or disable this rule.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet mask
of 255.255.255.255 in the subnet mask field to force the network number to be identical to the
host ID.