User Manual

Chapter 7 Wireless LAN
LTE3301 Series User’s Guide
76
Fig ure 44 Network > Wireless LAN > WPS
The following table describes the labels in this screen.
Table 28 Network > Wireless LAN > WPS
LABEL DESC RIPTIO N
WPS Setup
WPS Select Ena b le to turn on the WPS feature. Otherwise, select Disa b le .
PIN Code Select Ena ble and click Ap ply to allow the PIN Configuration method. If you select Disa b le ,
you cannot create a new PIN number.
PIN Number This is the WPS PIN (Personal Identification Number) of the LTE3301. Enter this PIN in the
configuration utility of the device you want to connect to the LTE3301 using WPS.
The PIN is not necessary when you use WPS push-button method.
Click G e ne ra te to generate a new PIN number.
WPS Status
Status This displays C o nfig ure d when the LTE3301 has connected to a wireless network using WPS or
when WPS Ena b le is selected and wireless or wireless security settings have been changed.
The current wireless and wireless security settings also appear in the screen.
This displays Unc o nfig ure d if WPS is disabled and there are no wireless or wireless security
changes on the LTE3301 or you click Re le a se C onfig ura tio n to remove the configured
wireless and wireless security settings.
Release
Configuration
This button is only available when the WPS status displays Co nfig ure d.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the LTE3301.
802.11 Mode This is the 802.11 mode used. Only compliant WLAN devices can associate with the LTE3301.
SSID This is the name of the wireless network (the LTE3301’s first SSID).
Security This is the type of wireless security employed by the network.
Apply Click Apply to save your changes back to the LTE3301.
Cancel Click Ca nc e l to reload the previous configuration for this screen.