User Manual

Chapter 7 Wireless LAN
LTE3301 Series User’s Guide
72
7.5 MAC Filte r Sc re e n
The MAC filter screen allows you to configure the LTE3301 to give exclusive access to devices (Allow) or
exclude devices from accessing the LTE3301 (De ny). Every Ethernet device has a unique MAC (Media
Access Control) address. The MAC address is assigned at the factory and consists of six pairs of
hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC address of the
devices to configure this screen.
To change your LTE3301’s MAC filter settings, click Ne two rk > Wire le ss LA N > MA C Filte r. The screen
appears as shown.
Intra-BSS Traffic A Basic Service Set (BSS) exists when all communications between wireless clients or between a
wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled, wireless
clients can access the wired network and communicate with each other. When Intra-BSS is
disabled, wireless clients can still access the wired network but cannot communicate with each
other.
WMM QoS Check this to have the LTE3301 automatically give a service a priority level according to the ToS
value in the IP header of packets it sends.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which
makes them run more smoothly.
Security Mode Select Sta tic WEP, WPA- PSK, WPA , WPA 2- PSK or WPA2 to add security on this wireless network.
The wireless clients which want to associate to this network must have same wireless security
settings as this device. After you select to use a security, additional options appears in this
screen. See
Section 7.3 on page 65 for detailed information on different security modes. Or you
can select No Se c urity to allow any client to associate this network without authentication.
Note: If the WPS function is enabled (default), only No Se c urity and WPA2- PSK are
available in this field.
Apply Click A pply to save your changes back to the LTE3301.
Cancel Click Ca nc e l to reload the previous configuration for this screen.
Table 24 Network > Wireless LAN > More AP: Edit (continued)
LABEL DESC RIPTIO N