User Manual

Table Of Contents
Chapter 7 Wireless LAN
LTE3301 Series User’s Guide
68
7.3.3 WPA- PSK/ WPA2- PSK
Select WPA- PSK or WPA2- PSK from the Se c urity Mo d e list.
Fig ure 37 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the LTE3301 and the wireless stations must use
the same WEP key for data transmission.
If you chose 64- b its, then enter any 5 ASCII characters or 10 hexadecimal characters ("0-9",
"A-F").
If you chose 128- bits, then enter 13 ASCII characters or 26 hexadecimal characters ("0-9", "A-
F").
You must configure at least one key, only one key can be activated at any one time. The
default key is key 1.
Apply Click Apply to save your changes back to the LTE3301.
Cancel Click C a nc e l to reload the previous configuration for this screen.
Table 20 Network > Wireless LAN > General: Static WEP (continued)
LABEL DESC RIPTIO N
Table 21 Network > Wireless LAN > General: WPA-PSK/WPA2-PSK
LABEL DESC RIPTIO N
Security Mode Select WPA- PSK or WPA2- PSK to enable data encryption.
WPA-PSK
Compatible
This field appears when you choose WPA2- PSK as the Se c urity Mo de .
Check this field to allow wireless devices using WPA- PSK security mode to connect to your
LTE3301.