User Manual

Chapter 17 Bandwidth Management
LTE3301 Series User’s Guide
116
Fig ure 77 Bandwidth Management Rule Configuration: Application List
The following table describes the labels in this screen.
See
Appendix C on page 173 for commonly used services and port numbers.
Table 53 Bandwidth Management Rule Configuration: Application List
LABEL DESC RIPTIO N
Rule Select Ena b le to turn on the bandwidth management rule. Otherwise, select Disa b le .
IP Address Enter the IP address or a range of IP addresses of the destination computer for whom this rule
applies.
Service Select Se rvic e Po rt and manually enter the port number(s) that defines the traffic type, for
example TCP port 80 defines web traffic.
Select Pre - de fine d App lic a tio n p ro file s to configure a bandwidth management rule for a
pre-defined service or application.
Protocol If you set Se rvic e to Se rvic e Po rt, select the protocol (TC P, or UDP) used for the service.
Service Type If you set Se rvic e to Pre - de fine d Ap plic a tio n pro file s, select the name of the service to which
the LTE3301 applies the bandwidth management rule.
Control Select Ma xim um Ba ndwid th or Minim um Ba ndwidth and specify the maximum or minimum
bandwidth allowed for the rule in KBps (kilobytes per second) or MBps (megabytes per
second).
Otherwise, select Prio rity and enter a priority level (from 1 to 7) for traffic that matches this
rule.
Direction Select To LA N&WLAN to apply the rule to traffic from WAN to LAN and WLAN.
Select To WAN to apply the rule to traffic from LAN/WLAN to WAN.
Select Both to apply the rule to traffic traveling in either direction.
Sharing Method This field is available only when you set Co ntrol to Ma xim um Ba ndwidth or Minim um
Ba ndwidth.
Select Gro uping to
Select Sing le to
Apply Click Ap ply to save your customized settings.
Cancel Click C a nc e l to exit this screen without saving.