User Manual

Chapter 12 Routing
LTE3301 Series User’s Guide
100
12.3 Dyna mic Ro uting Sc re e n
Use this screen to enable and configure RIP on the LTE3301. Click Ne two rk > Ro uting > Dyna m ic Routing
to open the Dyna m ic Routing screen.
Fig ure 66 Network > Routing > Dynamic Routing
The following table describes the labels in this screen.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the same
segment as your LTE3301's interface(s). The gateway helps forward packets to their
destinations.
Back Click Ba c k to return to the previous screen without saving.
Apply Click A p ply to save your changes back to the LTE3301.
Cancel Click C a nc e l to set every field in this screen to its last-saved value.
Table 43 Network > Routing > Static Route: Add/Edit
LABEL DESCRIPTIO N
Table 44 Network > Routing > Dynamic Routing
LABEL DESCRIPTIO N
Dynamic Routing RIP (Routing Information Protocol) allows a router to exchange routing information with other
routers. The RIP version controls the format and the broadcasting method of the RIP packets
that the LTE3301 sends (it recognizes both formats when receiving). RIP version 1 is universally
supported but RIP version 2 carries more information. RIP version 1 is probably adequate for
most networks, unless you have an unusual network topology.
Select the RIP version from RIPv1 and RIPv2. Otherwise, select Disa b le to turn if off.
Apply Click A pp ly to save your changes back to the LTE3301.
Cancel Click Ca nc e l to begin configuring this screen afresh.