ZyAIR G-3000 802.11g Business Access Point/Bridge/Repeater Quick Start Guide Version 3.
ZyAIR G-3000 Quick Start Guide Table of Contents 1 Introducing the ZyAIR ................................................................................................................ 4 2 Hardware Connections .............................................................................................................. 4 2.1 Side Panel and Connections ................................................................................................. 4 2.2 The LED Display.....................................
ZyAIR G-3000 Quick Start Guide 1 Introducing the ZyAIR The ZyAIR G-3000 is a wireless access point with two WLAN interfaces that are compliant with both IEEE802.11g and IEEE802.11b standards. It is suitable for wireless connections to the wired network in small office environments and businesses. The key features of the ZyAIR are the dual WLAN interface, internal RADIUS server, PoE (Power over Ethernet), wireless security, and WDS (Wireless Distribution System).
ZyAIR G-3000 Quick Start Guide LABEL DESCRIPTION CONSOLE Only connect this port if you want to configure the ZyAIR using the SMT (System Management Terminal) via console port; see your User’s Guide for details. Connect PS/2 end of the console cable to the console port of the ZyAIR and the other end to a serial port (COM1, COM2 or other COM port) on your computer.
ZyAIR G-3000 Quick Start Guide Figure 2 ZyAIR Front Panel 6
ZyAIR G-3000 Quick Start Guide Table 1 ZyAIR Front Panel LED Description LED BDG/RPT COLOR DESCRIPTION Blinking The ZyAIR is not ready or is rebooting in AP+Bridge or Bridge/Repeater mode. Off The ZyAIR has a successful reboot in AP+Bridge or Bridge/Repeater mode. On The ZyAIR is set up as an AP+Bridge or Bridge/Repeater. Off The ZyAIR is set up as an Access Point. Blinking (Breathing) ZyAIR is sending/receiving data through the wireless LAN.
ZyAIR G-3000 Quick Start Guide To access the ZyAIR, configure your computer’s IP address and subnet mask to be in the same range as the ZyAIR’s. The default IP address of the ZyAIR is 192.168.1.2. 3 Set Up Your Computer’s IP Address Skip this section if your computer’s IP address is already in the range of 192.168.1.3 ~ 192.168.1.254 with subnet mask 255.255.255.0. Your computer must have a network card and TCP/IP installed.
ZyAIR G-3000 Quick Start Guide 4. Select Internet Protocol (TCP/IP) and then click Properties. 5. Select Use the following IP Address and fill in an IP address (between 192.168.1.3 and 192.168.1.254). 6. Type 255.255.255.0 as the Subnet mask. 7. Click Advanced.1 Figure 5 Local Area Connection Properties Figure 6 Internet Protocol Properties 8. Remove any previously installed gateways in the IP Settings tab and click OK to go back to the Internet Protocol TCP/IP Properties screen.
ZyAIR G-3000 Quick Start Guide No gateways configured. Figure 7 Advanced TCP/IP Settings 9. Click OK to close the Internet Protocol (TCP/IP) Properties window. 10.Click Close (OK in Windows 2000/NT) to close the Local Area Connection Properties window. 11.Close the Network Connections window (Network and Dial-up Connections in Windows 2000/NT). 3.2 Checking/Updating Your Computer’s IP Address 1. In the computer, click Start, (All) Programs, Accessories and then Command Prompt. 2.
