User's Manual

Chapter 6 Interfaces
NXC CLI Reference Guide
60
6.5 Port Role Commands
The following table describes the commands available for port role identification. You must
use the
configure terminal command to enter the configuration mode before you can use
these commands.
6.5.1 Port Role Examples
The following are two port role examples..
6.6 USB Storage Specific Commands
Use these commands to configure settings that apply to the USB storage device connected to
the NXC.
Table 19 Command Summary: Port Role
COMMAND DESCRIPTION
show port type Displays the type of cable connection for each physical
interface on the device.
show module type Display the type of module for each physical interface on
the device.
Router(config)# show port type
Port Type
===========================================================================
1 Copper
2 Down
3 Down
4 Down
5 Down
6 Down
7 Down
8 Down
Router(config)# show module type
Port Type
===========================================================================
1 Copper
2 Copper
3 Copper
4 Copper
5 Fiber
6 Fiber
7 Fiber
8 Fiber