User's Manual

Chapter 36 Logs
NXC CLI Reference Guide
246
36.1.5 Console Port Log Commands
This table lists the commands for the console port settings.
36.1.6 Access Point Logging Commands
This table lists the commands for the Access Point settings.
 For the purposes of this device’s CLI, Access Points are referred to as WTPs.
Table 143 logging Commands: Console Port Settings
COMMAND DESCRIPTION
show logging status console Displays the current settings for the console log.
(This log is not discussed above.)
[no] logging console Enables the console log. The
no command
disables the console log.
logging console category module_name level
{alert | crit | debug | emerg | error | info |
notice | warn}
Controls whether or not debugging information for
the specified priority is displayed in the console log,
if logging for this category is enabled.
[no] logging console category module_name Enables logging for the specified category in the
console log. The no command disables logging.
Table 144 logging Commands: Access Point Settings
COMMAND DESCRIPTION
show wtp-logging status system-log [ap_mac] Displays the system log for the specified AP.
show wtp-logging entries [priority pri]
[category module_name] [srcip ipv4] [dstip
ipv4] [service service] [srciface
config_interface] [dstiface config_interface]
[protocol log_proto_accept][begin <1..512> end
<1..512>] [keyword keyword] [ap_mac]
Displays only the specified log entries for the
specified AP.
show wtp-logging entries field
{srcif|dstif|proto|time|msg|src|dst|note|pri|c
at|all} [begin <1..512> end <1..512>] [ap_mac]
Displays only log entries for specified fields for the
specified AP. You can display a range of field
entries from 1-512.
show wtp-logging debug status ap_mac Displays the debug status of the specified AP.
show wtp-logging debug entries [priority pri]
[category module_name] [srcip ipv4] [dstip
ipv4] [service service] [srciface
config_interface] [dstiface config_interface]
[protocol log_proto_accept ] [begin <1..512>
end <1..512>] [keyword keyword] [ap_mac]
Display only the specified debug log entries for the
specified AP.
show wtp-logging debug entries field {
srcif|dstif|proto
|time|msg|src|dst|note|pri|cat|all} [begin
<1..1024> end <1..1024>] [ap_mac]
Displays only the log entries for the specified fields
for the specified AP. You can display a range of
field entries from 1-1024.
show wtp-logging status syslog [ap_mac] Displays the logging status for the specified AP’s
syslog.