User's Manual

Chapter 35 File Manager
NXC CLI Reference Guide
225
 “exit” or “!'” must follow sub commands if it is to make the NXC exit sub
command mode.
Line 3 in the following example exits sub command mode.
Lines 1 and 3 in the following example are comments and line 4 exits sub command mode.
Lines 1 and 2 are comments. Line 5 exits sub command mode.
35.2.2 Errors in Configuration Files or Shell Scripts
When you apply a configuration file or run a shell script, the NXC processes the file line-by-
line. The NXC checks the first line and applies the line if no errors are detected. Then it
continues with the next line. If the NXC finds an error, it stops applying the configuration file
or shell script and generates a log.
You can change the way a configuration file or shell script is applied. Include
setenv stop-
on-error off
in the configuration file or shell script. The NXC ignores any errors in the
configuration file or shell script and applies all of the valid commands. The NXC still
generates a log for any errors.
35.2.3 NXC Configuration File Details
You can store multiple configuration files on the NXC. You can also have the NXC use a
different configuration file without the NXC restarting.
• When you first receive the NXC, it uses the system-default.conf configuration file of
default settings.
interface ge1
ip address dhcp
!
!
interface ge1
# this interface is a DHCP client
!
! this is from Joe
# on 2006/06/05
interface ge1
ip address dhcp
!