User's Manual

NXC CLI Reference Guide
117
CHAPTER 18
RTLS
Use the RTLS commands to use the managed APs as part of an Ekahau RTLS to track the
location of Ekahau Wi-Fi tags.
18.1 RTLS Introduction
Ekahau RTLS (Real Time Location Service) tracks battery-powered Wi-Fi tags attached to
APs managed by the NXC to create maps, alerts, and reports.
The Ekahau RTLS Controller is the centerpiece of the RTLS system. This server software runs
on a Windows computer to track and locate Ekahau tags from Wi-Fi signal strength
measurements. Use the NXC with the Ekahau RTLS system to take signal strength
measurements at the APs (Integrated Approach / Blink Mode).
18.2 RTLS Commands
The following table lists the rtls commands. You must use the configure terminal
command to enter the configuration mode before you can use these commands.
Table 55 rtls Commands
COMMAND DESCRIPTION
rtls ekahau activate Turn on RTLS to use Wi-Fi to track the location of
Ekahau Wi-Fi tags.
rtls ekahau ip address
ipv4_address
Specify the IP address of the Ekahau RTLS Controller.
rtls ekahau ip port <1..65535> Specify the server port number of the Ekahau RTLS
Controller.
rtls ekahau flush Clear the saved RTLS information from the NXC.
show rtls ekahau config Displays the RTLS configuration.
show rtls ekahau cli Displays the RTLS information recorded on the NXC.