ZyWALL User's Guide

Chapter 3 Wizard Setup
ZyWALL 2 Plus User’s Guide
72
Figure 16 ISP Parameters: PPPoE Encapsulation
The following table describes the labels in this screen.
Table 12 ISP Parameters: PPPoE Encapsulation
LABEL DESCRIPTION
ISP Parameter
for Internet
Access
Encapsulation Choose an encapsulation method from the pull-down list box. PPP over Ethernet
forms a dial-up connection.
Service Name Type the name of your service provider. This field is optional.
User Name Type the user name given to you by your ISP.
Password Type the password associated with the user name above.
Retype to
Confirm
Type your password again for confirmation.
Nailed-Up Select Nailed-Up if you do not want the connection to time out.
Idle Timeout Type the time in seconds that elapses before the router automatically disconnects
from the PPPoE server. The default time is 100 seconds.
WAN IP Address
Assignment
IP Address
Assignment
Select Dynamic If your ISP did not assign you a fixed IP address. This is the
default selection.
Select Static If the ISP assigned a fixed IP address.
The fields below are available only when you select Static.