ZyWALL User's Guide

Chapter 26 Maintenance
ZyWALL 2 Plus User’s Guide
461
If you uploaded the default configuration file you may need to change the IP address of your
computer to be in the same subnet as that of the default device IP address (192.168.1.1). See
your Quick Start Guide for details on how to set up your computer’s IP address.
If the upload was not successful, the following screen will appear. Click Return to go back to
the Configuration screen.
Figure 294 Configuration Upload Error
26.11.3 Back to Factory Defaults
Click the Reset button to clear all user-entered configuration information and return the
ZyWALL to its factory defaults as shown on the screen. The following warning screen
appears.
Figure 295 Reset Warning Message
You can also press the hardware RESET button to reset the factory defaults of your
ZyWALL. Refer to Section 2.3 on page 53 for more information on the RESET button.
26.12 Restart Screen
System restart allows you to reboot the ZyWALL without turning the power off.
Click MAINTENANCE > Restart. Click Restart to have the ZyWALL reboot. Restart is
different to reset; (see Section 26.11.3 on page 461) reset returns the device to its default
configuration.