Wireless Gateway Series User's Guide

ZyAIR Wireless Gateway Series User’s Guide
WAN Screens
8-11
Table 8-5 IP Setup
LABEL DESCRIPTION
Allow between
LAN and WAN
Select this check box to forward NetBIOS packets from the LAN to the WAN and
from the WAN to the LAN. If your firewall is enabled with the default policy set to
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall
rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN
and from the WAN to the LAN.
Allow Trigger Dial Select this option to allow NetBIOS packets to initiate calls.
Apply
Click Apply to save your changes back to the ZyAIR.
Reset
Click Reset to begin configuring this screen afresh.
8.5 Configuring WAN MAC
To change your ZyAIR’s WAN MAC settings, click ADVANCED, WAN and then the MAC tab. The
screen appears as shown.
Figure 8-6 MAC Setup
The MAC address screen allows users to configure the WAN port's MAC address by either using the factory
default or cloning the MAC address from a computer on your LAN. Choose Factory Default to select the
factory assigned default MAC address.