User`s guide
Table Of Contents
- VMG8924-B10A and VMG8924- B30A Series
- User’s Guide
- Technical Reference
- Network Map and Status Screens
- Broadband
- Wireless
- Home Networking
- 7.1 Overview
- 7.2 The LAN Setup Screen
- 7.3 The Static DHCP Screen
- 7.4 The UPnP Screen
- 7.5 Installing UPnP in Windows Example
- 7.6 Using UPnP in Windows XP Example
- 7.7 The Additional Subnet Screen
- 7.8 The STB Vendor ID Screen
- 7.9 The 5th Ethernet Port Screen
- 7.10 The LAN VLAN Screen
- 7.11 The Wake on LAN Screen
- 7.12 Technical Reference
- Routing
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Interface Group
- USB Service
- Power Management
- Firewall
- MAC Filter
- Parental Control
- Scheduler Rule
- Certificates
- VPN
- Voice
- Log
- Traffic Status
- VoIP Status
- ARP Table
- Routing Table
- IGMP/MLD Status
- xDSL Statistics
- 3G Statistics
- User Account
- Remote Management
- TR-069 Client
- TR-064
- SNMP
- Time Settings
- E-mail Notification
- Logs Setting
- Firmware Upgrade
- Configuration
- Diagnostic
- Troubleshooting
- Customer Support
- Setting up Your Computer’s IP Address
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Wireless LANs
- IPv6
- Services
- Legal Information
- Index
VMG8924-B10A and VMG8924-B30A Series User’s Guide 291
CHAPTER 31
Remote Management
31.1 Overview
Remote management controls through which interface(s), which services can access the Device.
Note: The Device is managed using the Web Configurator.
31.2 The Remote MGMT Screen
Use this screen to configure through which interface(s), which services can access the Device. You
can also specify the port numbers the services must use to connect to the Device. Click
Maintenance > Remote MGMT to open the following screen.
Figure 168 Maintenance > Remote MGMT
The following table describes the fields in this screen.
Table 138 Maintenance > Remote MGMT
LABEL DESCRIPTION
WAN Interface
used for
services
Select Any WAN to have the Device automatically activate the remote management service
when any WAN connection is up.
Select Multi WAN and then select one or more WAN connections to have the Device
activate the remote management service when the selected WAN connections are up.
HTTP This is the service you may use to access the Device.
LAN/WLAN Select the Enable check box for the corresponding services that you want to allow access to
the Device from the LAN/WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to
the Device from the WAN.