User`s guide
Table Of Contents
- VMG8924-B10A and VMG8924- B30A Series
- User’s Guide
- Technical Reference
- Network Map and Status Screens
- Broadband
- Wireless
- Home Networking
- 7.1 Overview
- 7.2 The LAN Setup Screen
- 7.3 The Static DHCP Screen
- 7.4 The UPnP Screen
- 7.5 Installing UPnP in Windows Example
- 7.6 Using UPnP in Windows XP Example
- 7.7 The Additional Subnet Screen
- 7.8 The STB Vendor ID Screen
- 7.9 The 5th Ethernet Port Screen
- 7.10 The LAN VLAN Screen
- 7.11 The Wake on LAN Screen
- 7.12 Technical Reference
- Routing
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Interface Group
- USB Service
- Power Management
- Firewall
- MAC Filter
- Parental Control
- Scheduler Rule
- Certificates
- VPN
- Voice
- Log
- Traffic Status
- VoIP Status
- ARP Table
- Routing Table
- IGMP/MLD Status
- xDSL Statistics
- 3G Statistics
- User Account
- Remote Management
- TR-069 Client
- TR-064
- SNMP
- Time Settings
- E-mail Notification
- Logs Setting
- Firmware Upgrade
- Configuration
- Diagnostic
- Troubleshooting
- Customer Support
- Setting up Your Computer’s IP Address
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Wireless LANs
- IPv6
- Services
- Legal Information
- Index
Chapter 1 Introducing the Device
VMG8924-B10A and VMG8924-B30A Series User’s Guide
24
To activate WPS:
1 Make sure the PWR/SYS LED is on and not blinking.
2 Press the WPS button for five seconds and release it.
3 Press the WPS button on another WPS-enabled device within range of the Device. The WiFi 2.4G
LED flashes orange while the Device sets up a WPS connection with the other wireless device.
4 Once the connection is successfully made, the WiFi 2.4G LED shines green.
To turn off the wireless network, press the Wi-Fi button for one to five seconds. The WiFi 2.4G
LED turns off when the wireless network is off.
1.8 Wall-mounting Instructions
Do the following to hang your Device on a wall.
1 Locate a high position on a wall that is free of obstructions. Use a sturdy wall.
2 Hold the bracket against the wall and mark where to drill the holes.
3 Drill the two screw holes in the wall.
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
4 Align and insert the bracket to the wall-mounting notches on the rear panel of the Device.