User`s guide
Table Of Contents
- VMG8924-B10A and VMG8924- B30A Series
- User’s Guide
- Technical Reference
- Network Map and Status Screens
- Broadband
- Wireless
- Home Networking
- 7.1 Overview
- 7.2 The LAN Setup Screen
- 7.3 The Static DHCP Screen
- 7.4 The UPnP Screen
- 7.5 Installing UPnP in Windows Example
- 7.6 Using UPnP in Windows XP Example
- 7.7 The Additional Subnet Screen
- 7.8 The STB Vendor ID Screen
- 7.9 The 5th Ethernet Port Screen
- 7.10 The LAN VLAN Screen
- 7.11 The Wake on LAN Screen
- 7.12 Technical Reference
- Routing
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Dynamic DNS Setup
- Interface Group
- USB Service
- Power Management
- Firewall
- MAC Filter
- Parental Control
- Scheduler Rule
- Certificates
- VPN
- Voice
- Log
- Traffic Status
- VoIP Status
- ARP Table
- Routing Table
- IGMP/MLD Status
- xDSL Statistics
- 3G Statistics
- User Account
- Remote Management
- TR-069 Client
- TR-064
- SNMP
- Time Settings
- E-mail Notification
- Logs Setting
- Firmware Upgrade
- Configuration
- Diagnostic
- Troubleshooting
- Customer Support
- Setting up Your Computer’s IP Address
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Wireless LANs
- IPv6
- Services
- Legal Information
- Index
Chapter 13 USB Service
VMG8924-B10A and VMG8924-B30A Series User’s Guide
188
13.2 The File Sharing Screen
Use this screen to set up file sharing through the Device. The Device’s LAN users can access the
shared folder (or share) from the USB device inserted in the Device. To access this screen, click
Network Setting > USB Service > File Sharing.
Figure 106 Network Setting > USB Service > File Sharing
Each field is described in the following table.
Table 76 Network Setting > Home Networking > File Sharing
LABEL DESCRIPTION
Information
Volume This is the volume name the Device gives to an inserted USB device.
Capacity This is the total available memory size (in megabytes) on the USB device.
Used Space This is the memory size (in megabytes) already used on the USB device.
Server Configuration
File Sharing
Services
Select Enable to activate file sharing through the Device.
Host Name Enter the host name on the share.
Share Directory List
Add New Share
Click this to create a new share for users to access through the Device.
Active Select this to activate the share.
Status This field shows the status of the share.
: The share is not activated.
: The share is activated and shared to all users.
: The share is activated and only shared to the specified users listed in the Account
Management section below.