Vantage Service Gateway User's Guide

VSG-1200 V2 User’s Guide
173 Chapter 24 Syslog
The following table describes the log formats.
Description This field displays a short description about the syslog.
Interval Time This field displays how often the VSG sends the logs. If available, enter the number
of minutes the VSG waits between sending the syslog.
Type This field displays the type number of a log. This number is read-only.
Apply Click Apply to save the settings.
Table 56 Logs: Log Format
SYSLOG NAME FORMAT CREATED
System
Information
Id <MAC Address> System Uptime <0 days 00h:04m:00s>
WAN <FrameTxOK| FrameRxOK| FrameTxError|
FrameRxError> LAN <FrameTxOK| FrameRxOK|
FrameTxError| FrameRxError>
Each time interval
specified (between
1 and 10080
minutes).
System Boot
Notice
Id <MAC Address> System Up Each time when
the device reboots.
System Account
Activity
Information
Id <MAC Address> System Account Activity Information
<Username, User IP, Status>
Where:
Username = Administrator | Supervisor | Accounting Operator
User IP = IP Address
Status = Login | Logout | Idle Time Out
Each time when
the system account
logs in or logs out.
Account Created Id <Mac Address> Account Create <username, Account
usage time, Billing profile information>
Where:
Username = Single account <username> or Batch account
<prefix, from, to, postfix>]
Billing profile information = index, name
When an account
is created.
Subscriber
Trace
Id <MAC Address> Subscriber Trace <username, user IP,
user MAC, interface, login time, logout time, RxData count,
TxData count>
When a subscriber
logs out.
Logged-in Users Id <MAC Address> Logged-in Users <Number of Logged-in
users, Start Number, End Number) (Username, user IP, user
MAC, interface, login time, RxData count, TxData count>
[additional information]
Each time interval
specified.
User Agreement
Billing Log Id <Mac Address> Billing Log <Username, Billing profile
information, Log time, Usage time, Bill, Charge From>
Where:
Charge From = PMS | Dynamic
Billing profile name = Name
Log time = MM/DD/YYYY HH:MM:SS
Usage time = “x minutes” | “Expire when 00:00”
Billing profile information = index, name
When a log is
created
Table 55 Logs: Log Settings (continued)
LABEL DESCRIPTION