Unified Security Gateway User's Guide

Chapter 4 Wizard Setup
ZyWALL USG 300 User’s Guide
98
Name: Type the name used to identify this VPN connection (and VPN gateway). You may use
1-31 alphanumeric characters, underscores(
_), or dashes (-), but the first character cannot be a
number. This value is case-sensitive.
Secure Gateway: Enter the WAN IP address or domain name of the remote IPSec router
(secure gateway). Use 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address and
no domain name.
Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same
password. Use 8 to 31 case-sensitive ASCII characters or 16 to 62 hexadecimal (“0-9”, “A-F”)
characters. Proceed hexadecimal characters with “0x”.
Figure 35 VPN Express Wizard: Step 3
The following table describes the labels in this screen.
Table 16 VPN Express Wizard: Step 3
LABEL DESCRIPTION
Local Policy
(IP/Mask)
Type a static local IP address that corresponds to the remote IPSec router's
configured remote IP address (the remote IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind your ZyWALL.
Remote Policy
(IP/Mask)
Type a static local IP address that corresponds to the remote IPSec router's
configured local IP address (the local IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind the remote gateway.
Next Click Next to continue.