Unified Security Gateway User's Guide

Chapter 27 Application Patrol
ZyWALL USG 300 User’s Guide
398
Schedule Select a schedule that defines when the policy applies or select Create Object to
configure a new one (see Chapter 37 on page 527 for details). Otherwise, select
any to make the policy always effective.
User Select a user name or user group to which to apply the policy. Select Create
Object to configure a new user account (see Section 34.2.1 on page 506 for
details). Select any to apply the policy for every user.
From Select the source zone of the traffic to which this policy applies.
To Select the destination zone of the traffic to which this policy applies.
Source Select a source address or address group for whom this policy applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
source.
Destination Select a destination address or address group for whom this policy applies. Select
Create Object to configure a new one. Select any if the policy is effective for every
destination.
Protocol Select the protocol for which this condition applies. Choices are: TCP and UDP.
Select any to apply the policy to both TCP and UDP traffic.
Access This field controls what the ZyWALL does with packets that match this policy.
Choices are:
forward - the ZyWALL routes the packets.
Drop - the ZyWALL does not route the packets and does not notify the client of its
decision.
Reject - the ZyWALL does not route the packets and notifies the client of its
decision.
Bandwidth
Management
Configure these fields to set the amount of bandwidth the application can use.
These fields only apply when Access is set to forward.
Inbound kbps Type how much inbound bandwidth, in kilobits per second, this policy allows the
traffic to use. Inbound refers to the traffic the ZyWALL sends to a connection’s
initiator.
If you enter 0 here, this policy does not apply bandwidth management for the
matching traffic that the ZyWALL sends to the initiator. Traffic with bandwidth
management disabled (inbound and outbound are both set to 0) is automatically
treated as the lowest priority (7).
If the sum of the bandwidths for routes using the same next hop is higher than the
actual transmission speed, lower priority traffic may not be sent if higher priority
traffic uses all of the actual bandwidth.
Outbound
kbps
Type how much outbound bandwidth, in kilobits per second, this policy allows the
traffic to use. Outbound refers to the traffic the ZyWALL sends out from a
connection’s initiator.
If you enter 0 here, this policy does not apply bandwidth management for the
matching traffic that the ZyWALL sends out from the initiator. Traffic with bandwidth
management disabled (inbound and outbound are both set to 0) is automatically
treated as the lowest priority (7).
If the sum of the bandwidths for routes using the same next hop is higher than the
actual transmission speed, lower priority traffic may not be sent if higher priority
traffic uses all of the actual bandwidth.
Table 117 AppPatrol > Other > Edit (continued)
LABEL DESCRIPTION