Unified Security Gateway User's Guide

Chapter 27 Application Patrol
ZyWALL USG 300 User’s Guide
389
Figure 304 AppPatrol > General
The following table describes the labels in this screen. See Section 27.9.1 on page 391 for
more information as well.
Table 112 AppPatrol > General
LABEL DESCRIPTION
Enable
Application
Patrol
Select this check box to turn on application patrol.
Enable BWM This is a global setting for enabling or disabling bandwidth management on the
ZyWALL. You must enable this setting to have individual policy routes or
application patrol policies apply bandwidth management.
This same setting also appears in the Network > Routing > Policy Route screen.
Enabling or disabling it in one screen also enables or disables it in the other screen.
Registration The following fields display information about the current state of your subscription
for IDP/application patrol signatures.
Registration
Status
This field displays whether a service is activated (Licensed) or not (Not Licensed)
or expired (Expired).
Registration
Type
This field displays whether you applied for a trial application (Trial) or registered a
service with your iCard’s PIN number (Standard). None displays when the service
is not activated.
Apply new
Registration
This link appears if you have not registered for the service or only have the trial
registration. Click this link to go to the screen where you can register for the
service.
Signature
Information
The following fields display information on the current signature set that the
ZyWALL is using.
Current
Version
This field displays the IDP signature and anomaly rule set version number. This
number gets larger as the set is enhanced.
Released
Date
This field displays the date and time the set was released.
Update
Signatures
Click this link to go to the screen you can use to download signatures from the
update server.