Network Router User Manual

72 Fax Operation
Command Function
#C2 Set minimum scan line time capability of the
receiver: 10 ms at 3.85 line/mm, T(7.7)=T(3.85).
#C3 Set minimum scan line time capability of the
receiver: 20 ms at 3.85 line/mm, T(7.7)=1/2
T(3.85).
#C4 Set minimum scan line time capability of the
receiver: 40 ms at 3.85 line/mm, T(7.7)=T(3.85).
#C5 Set minimum scan line time capability of the
receiver: 40 ms at 3.85 line/mm, T(7.7)=1/2
T(3.85).
#C6 Set minimum scan line time capability of the
receiver: 10 ms at 3.85 line/mm, T(7.7)=1/2
T(3.85).
#C7 Set minimum scan line time capability of the
receiver: 0 ms at 3.85 line/mm, T(7.7)=T(3.85).
#P<string> Set local phone number to the phone number
following the character 'P' can store up to 25
characters. The modem will exchange this phone
number with the remote fax machine during initial
handshaking.
Status Report Result Codes
When your modem is in fax mode, each ATD or ATA command
will try to establish a fax connection. Your modem will send a
status report result code back to the DTE (computer).
NO DIAL
TONE
Tried to dial but no dial tone is detected.
NO CARRIER Handshake fails or no carrier is detected or
time-out.
BUSY Other party's phone line is busy.
NO ANSWER Quiet answer is not detected before time-out.