Network Router User Manual

AT Command Set Summaries 91
Command Options Function & Description Ref.
*M1 Set to Answer mode.
*Pn n=0-15
*P11 *
Set leased line transmission power
level; ranges from 0 dBm to -15
dBm (default: -11 dBm) (see also
S35.3).
S17.1-4
*Qn Action taken when line quality
changes.
S27.6-7
*Q0 No action to poor signal quality.
*Q1 Retrain action taken if signal quality
is poor. (See also S41.2)
*Q2 * Adaptive rate, automatic fall-back or
forward.
*Q3 Disconnect if signal quality is poor.
*Rab Read remote profile “b” to local user S36.1
a=0-3 Local user profile number “a”. S37.4-7
b=0-3 Remote user profile number “b”. S37.0-3
b=4 Remote active configuration.
b=5 Remote factory default
configuration.
*T Recall the last CND (Caller ID)
information..
S40.2
*V View the Password table.
*Wab Write local configuration profile “a”
to remote user profile “b” and reset
remote modem from profile “b”.
S36.1
a=0-3 Local user profile number “a”. S37.4-7
a=4 Local active configuration.
a=5 Local factory default configuration.
b=0-3 Remote user profile number “b”. S37.0-3
The AT+F commands are located in the chapter 7.