User manual

4 Initial Setup
Before running the setup utility, make sure you have the IP Camera properly connected.
To begin setup, insert the installation CD supplied with the camera into the CD-ROM
drive of the viewing PC, and the eaZy Wizard utility will start and guide you during the
installation process of the hardware and software for your IP camera.
4.1 Adjusting the Focus
After initial setup, the camera’s focus will need to be adjusted. In order to
adjust focus, aim the camera at the area you wish to monitor and gently turn
the focus adjustment ring, located at the front of the camera. Turning the
ring clockwise will move the focus farther away, while turning
counterclockwise will move the focus closer.
Important: Do not over-tighten the adjustment ring, as this
may damage the unit.