P-660HW-T v2 802.11g Wireless ADSL 2+ 4-port Gateway Quick Start Guide Version 3.
P-660HW-T v2 Quick Start Guide Overview The P-660HW-T v2 is an ADSL router with a four-port built-in Ethernet switch and IEEE 802.11b/g wireless capability. The P-660HW-T v2 allows wired and wireless clients to safely access the Internet. See your User’s Guide for background information on all features. How to use the included CD This CD provides multi-media animations that help you set up your P-660HW-T v2. 1 On the included CD, click Multimedia Auto Provisioner > Installation Tutorial.
P-660HW-T v2 Quick Start Guide 2 ETHERNET: Use an Ethernet cable to connect a computer to an ETHERNET port for initial configuration and/or Internet access. 3 POWER: Use the power adaptor provided with your P-660HW-T v2 to connect an appropriate power source to the POWER socket. Make sure the power source is on. 4 Push in the POWER button. Look at the lights on the front panel. • The POWER light blinks while your P-660HW-T v2 starts up and stays on once it is ready.
P-660HW-T v2 Quick Start Guide 3 See the User’s Guide for field descriptions of the Status screen. 3 Internet and Wireless Setup 1 Open your web browser, and go to http://www.zyxel.com. Your P-660HW-T v2 tries to detect your Internet connection. Wait for the P-660HW-T v2 to finish detection. If any other screens appear, follow the directions in the screen. If the web page opens correctly, your P-660HW-T v2 is ready for you to use. If the web page does not open, follow the rest of the steps.
P-660HW-T v2 Quick Start Guide 4 Follow the directions in the screens. 5 Click Go to Wizard setup. Then, click Apply. 6 Click INTERNET/WIRELESS SETUP. Wait while your P-660HW-T v2 tries to detect your DSL connection. 7 Follow the directions in the wizard. Do not change default settings if your ISP did not provide information.
P-660HW-T v2 Quick Start Guide Enable OTIST only if your wireless clients support WPA and OTIST. You must enable OTIST on the P-660HW-T v2 and all wireless clients (in any order) within three minutes. To enable OTIST on the P-660HW-T v2, you can either use the wizard (see Section 3 on page 4) or hold in the RESET button (see Section 1 on page 2) for three to eight seconds. Do not hold the RESET button in for too long, as this will reset the P-660HW-T v2 to the factory defaults.
