P-660HW-D 802.11g Wireless ADSL 2+ 4-port Gateway Quick Start Guide Version 3.
P-660HW-D Series Quick Start Guide Overview The P-660HW-D is an ADSL router with a four-port built-in switch and IEEE 802.11b/g wireless capability. See your User’s Guide for background information on all features. How to use the included CD This CD provides multi-media animations that help you set up your P-660HW-D. 1 On the included CD, click Multimedia Auto Provisioner > Installation Tutorial. 2 At the end of the tutorial, click Configuration Genie.
P-660HW-D Series Quick Start Guide 2 ETHERNET: Use an Ethernet cable to connect a computer to the ETHERNET port for initial configuration and/or Internet access. 3 POWER: Use the power adaptor provided with your P-660HW-D to connect an appropriate power source to the POWER socket. Make sure the power source is on. 4 Push in the POWER button. Look at the lights on the front panel. • The POWER light and the DSL light blink while your P-660HW-D starts up and stay on once the DSL connection is ready.
P-660HW-D Series Quick Start Guide 3 See the User’s Guide for field descriptions of the Status screen. 3 Internet and Wireless Setup 1 Open your web browser, and go to http://www.zyxel.com. Your P-660HW-D tries to detect your Internet connection. Wait for the P-660HW-D to finish detection. If any other screens appear, follow the directions in the screen. If the web page opens correctly, your P-660HW-D is ready for you to use. If the web page does not open, follow the rest of the steps.
P-660HW-D Series Quick Start Guide 4 Follow the directions in the screens. 5 Click Go to Wizard setup. Then, click Apply. 6 Click INTERNET/WIRELESS SETUP. Wait while your P-660HW-D tries to detect your DSL connection. 7 Follow the directions in the wizard. Do not change default settings if your ISP did not provide information.
P-660HW-D Series Quick Start Guide If you enable OTIST and select Manually assign a WEP key using the wireless wizard, the P660HW-D will replace the WEP key with a WPA-PSK. Enable OTIST only if your wireless clients support WPA and OTIST. You must enable OTIST on the P-660HW-D and all wireless clients within three minutes in any order. To enable OTIST on the P-660HW-D, you can either use the wizard (see Section 3 on page 4) or hold in the RESET button (see Section 1 on page 2) for one to five seconds.
