P-660HN-TxA 802.11n Wireless ADSL2+ 4-port Gateway Firmware v3.40 Edition 1, 6/2010 DEFAULT LOGIN DETAILS IP Address: http://192.168.1.1 Password: 1234 www.zyxel.
Device Panels WPS/WLAN BUTTON POWER LAN1-4 DSL PORT WPS/WLAN DSL INTERNET LAN PORT 1-4 RESET POWER ON/OFF 2
P-660HN-TxA Overview The P-660HN-TxA is an ADSL router with a four-port built-in Ethernet switch and IEEE 802.11n wireless capability. The P-660HN-TxA allows wired and wireless clients to safely access the Internet. Hardware Connections This section shows you how to set up your P-660HN-TxA.
1. DSL: Use a telephone wire to connect your P-660HN-TxA’s DSL port to a telephone jack (or to a splitter, if one is already installed). 2. LAN: Use an Ethernet cable to connect a computer to a LAN port for initial configuration and/or Internet access. 3. POWER: Use the power adaptor provided with your P-660HN-TxA to connect an appropriate power source to the POWER socket. Make sure the power source is on. 4. Push the ON/OFF button to the ON position. Look at the lights on the front panel.
P-660HN-TxA Internet and Wireless Setup 1. In your browser, go to http://192.168.1.1. 2. Enter the default password 1234 and click Login. 3. Select Go to Advanced Setup then click Apply.
4. The Status screen displays. Open the Network > Wireless LAN > AP screen. 5. Select Enable Wireless LAN, then select the country in which your P-660HN-TxA operates.
P-660HN-TxA 6. Next select a channel from the Channel Selection list. Channels available vary according to the country you select. 7. Click Apply to save your settings. 8. Type http://www.zyxel.com in your web browser’s address bar and press [Enter]. Your P-660HN-TxA tries to detect your Internet connection. Wait for the P-660HN-TxA to finish detection. If any other screens appear, follow the directions in the screen. If the web page opens correctly, your P-660HN-TxA is ready for you to use.
11. Click INTERNET/WIRELESS SETUP. Wait while your P-660HN-TxA tries to detect your DSL connection. 12. Follow the directions in the wizard. Do not change default settings if your ISP did not provide information. Troubleshooting 1.
P-660HN-TxA connected. If the lights are still different, turn off the device, wait a few seconds, and turn it on again. b. Follow the steps on page 8 again. Make sure you enter the correct information. For example, if your account has a user name and password, make sure you type it correctly. In addition, if you are not sure which encapsulation your ISP uses, contact your ISP. c. If you are using a new Internet account, contact your ISP to make sure it is active. d.
