User`s guide

Chapter 21 Tools
P-660HN-Fx User’s Guide
293
Configuration Backup Using GUI-based TFTP Clients
The following table describes some of the fields that you may see in GUI-based TFTP clients.
Refer to Section 21.1.2 on page 287 to read about configurations that disallow TFTP and FTP
over WAN.
21.2 The Firmware Screen
Click Maintenance > Tools to open the Firmware screen. Follow the instructions in this
screen to upload firmware to your ZyXEL Device. The upload process uses HTTP (Hypertext
Transfer Protocol) and may take up to two minutes. After a successful upload, the system will
reboot. See Section 21.1.4 on page 289 for upgrading firmware using FTP/TFTP commands.
1 Do NOT turn off the ZyXEL Device while firmware upload is in progress!
Figure 175 Maintenance > Tools > Firmware
Table 121 General Commands for GUI-based TFTP Clients
COMMAND DESCRIPTION
Host Enter the IP address of the ZyXEL Device. 192.168.1.1 is the ZyXEL Device’s default IP
address when shipped.
Send/Fetch Use “Send” to upload the file to the ZyXEL Device and “Fetch” to back up the file on your
computer.
Local File Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File This is the filename on the ZyXEL Device. The filename for the firmware is “ras” and for
the configuration file, is “rom-0”.
Binary Transfer the file in binary mode.
Abort Stop transfer of the file.