User`s guide

Chapter 15 Quality of Service (QoS)
P-660HN-Fx User’s Guide
232
See Appendix E on page 371 for a list of commonly-used services. The following table
describes the labels in this screen.
Table 85 Advanced > QoS > Class Setup: Edit
LABEL DESCRIPTION
Class Configuration
Active Select the check box to enable this classifier.
Name The text may consist of up to 20 letters, numerals and any printable character
found on a typical English language keyboard.
Interface Select from which interface traffic of this class should come.
Priority Select a priority level (between 0 and 7) or select Auto to have the ZyXEL
Device map the matched traffic to a queue according to the internal QoS
mapping table. See Section 15.5.4 on page 236 for more information.
"0" is the lowest priority level and "7" is the highest.
Routing Policy Select the next hop to which traffic of this class should be forwarded.
Select By Routing Table to have the ZyXEL Device use the routing table to find
a next hop and forward the matched packets automatically.
Select To WAN Index to route the matched packets through the specified PVC.
This option is available only when the WAN type is ADSL.
Select To Gateway Address to route the matched packets to the router or
switch you specified in the Gateway Address field.
WAN Index Select a PVC index number.
Gateway
Address
Enter the IP address of the gateway, which should be a router or switch on the
same segment as the ZyXEL Device’s interface(s), that can forward the packet
to the destination.
Order This shows the ordering number of this classifier. Select an existing number for
where you want to put this classifier and click Apply to move the classifier to the
number you selected. For example, if you select 2, the classifier you are moving
becomes number 2 and the previous classifier 2 gets pushed down one.
Tag Configuration
DSCP Value Select Same to keep the DSCP fields in the packets.
Select Auto to map the DSCP value to 802.1 priority level automatically.
Select Mark to set the DSCP field with the value you configure in the field
provided.
802.1Q Tag Select Same to keep the priority setting and VLAN ID of the frames.
Select Auto to map the 802.1 priority level to the DSCP value automatically.
Select Remove to delete the priority queue tag and VLAN ID of the frames.
Select Mark to replace the 802.1 priority field and VLAN ID with the value you
set in the fields below.
Select Add to treat all matched traffic untagged and add a second priority queue
tag and VLAN.
Ethernet Priority Select a priority level (between 0 and 7) from the drop down list box.
VLAN ID Specify a VLAN ID number between 2 and 4094.
Filter Configuration Use the following fields to configure the criteria for traffic classification.
Source
Address Select the check box and enter the source IP address in dotted decimal notation.
A blank source IP address means any source IP address.
Subnet
Netmask
Enter the source subnet mask. Refer to the appendix for more information on IP
subnetting.