User`s guide

Chapter 15 Quality of Service (QoS)
P-660HN-Fx User’s Guide
230
15.3 The Class Setup Screen
Use this screen to add, edit or delete classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port
number, destination port number or incoming interface. For example, you can configure a
classifier to select traffic from the same protocol port (such as Telnet) to form a flow.
Click Advanced > QoS > Class Setup to open the following screen.
Figure 139 Advanced > QoS > Class Setup
The following table describes the labels in this screen.
15.3.1 The Class Configuration Screen
Use this screen to configure a classifier. Click the Add button or the Edit icon in the Modify
field to display the following screen.
Table 84 Advanced > QoS > Class Setup
LABEL DESCRIPTION
Create a new Class Click this to create a new classifier.
No This is the number of each classifier. The ordering of the classifiers is important
as the classifiers are applied in turn.
Active Select the check box to enable this classifier.
Name This is the name of the classifier.
Interface This shows the interface from which traffic of this classifier should come.
Priority This is the priority assigned to traffic of this classifier.
Filter Content This shows criteria specified in this classifier.
Modify Click the Edit icon to go to the screen where you can edit the classifier.
Click the Remove icon to delete an existing classifier.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.