User`s guide

Chapter 13 Static Route
P-660HN-Fx User’s Guide
213
13.2.1 Static Route Edit
Use this screen to configure the required information for a static route. Select a static route
index number and click Edit. The screen shown next appears.
Figure 124 Advanced > Static Route: Edit
The following table describes the labels in this screen.
Table 79 Advanced > Static Route: Edit
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Route Name Enter the name of the IP static route. The text may consist of up to 9 letters,
numerals and any printable character found on a typical English language
keyboard. Leave this field blank to delete this static route.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway Type Use either Gateway Address or Gateway Node to configure a static route.
Gateway IP
Address
This field is available when you select Gateway Address from Gateway Type.
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
Gateway Node This field is available when you select Gateway Node from Gateway Type.
Select a remote node to set the static route. A remote note is a connection point
outside of the local area network. One example of a remote node is your connection
to your ISP. See Section 5.3 on page 75 for details on configuring a remote node.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.