User`s guide

Chapter 11 Packet Filter
P-660HN-Fx User’s Guide
179
Figure 102 Security > Packet Filter > Edit (Protocol Filter)
The following table describes the labels in this screen.
11.2.2 Configuring Protocol Filter Rules
Use this screen to configure protocol filter rules. In the Edit (Protocol Filter) screen, click an
Edit icon to display the following screen.
Table 62 Security > Packet Filter > Edit (Protocol Filter)
LABEL DESCRIPTION
# This is the index number of the rules in a filter set.
Active Use the check box to turn a filter rule on or off.
Filter Type This field displays whether the filter type is a protocol filter or generic filter.
Protocol This field displays the upper layer protocol.
SA This field displays the source IP address.
DA This field displays the destination IP address.
Modify Click the Edit icon to configure a filter rule.
Click the Remove icon to delete a filter rule.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.