User`s guide

Chapter 9 Firewalls
P-660HN-Fx User’s Guide
161
Action for Matched
Packet
Use the drop-down list box to select whether to discard (Drop), deny and send
an ICMP destination-unreachable message to the sender of (Reject) or allow the
passage of (Permit) packets that match this rule.
Source/Destination Address
Address Type Do you want your rule to apply to packets with a particular (single) IP, a range of
IP addresses (for instance, 192.168.1.10 to 192.169.1.50), a subnet or any IP
address? Select an option from the drop-down list box that includes: Single
Address, Range Address, Subnet Address and Any
Address.
Start IP Address Enter the single IP address or the starting IP address in a range here.
End IP Address Enter the ending IP address in a range here.
Subnet Mask Enter the subnet mask here, if applicable.
Add >> Click Add >> to add a new address to the Source or Destination Address box.
You can add multiple addresses, ranges of addresses, and/or subnets.
Edit << To edit an existing source or destination address, select it from the box and click
Edit <<.
Delete Highlight an existing source or destination address from the Source or
Destination Address box above and click Delete to remove it.
Services
Available/ Selected
Services
Please see Appendix E on page 371 for more information on services available.
Highlight a service from the Available Services box on the left, then click Add
>> to add it to the Selected Services box on the right. To remove a service,
highlight it in the Selected Services box on the right, then click Remove.
Edit Customized
Service
Click the Edit Customized Services link to bring up the screen that you use to
configure a new custom service that is not in the predefined list of services.
Schedule
Day to Apply Select everyday or the day(s) of the week to apply the rule.
Time of Day to
Apply (24-Hour
Format)
Select All Day or enter the start and end times in the hour-minute format to apply
the rule.
Log
Log Packet Detail
Information
This field determines if a log for packets that match the rule is created or not. Go
to the Log Settings page and select the Access Control logs category to have
the ZyXEL Device record these logs.
Alert
Send Alert
Message to
Administrator When
Matched
Select the check box to have the ZyXEL Device generate an alert when the rule
is matched.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Table 54 Security > Firewall > Rules: Edit (continued)
LABEL DESCRIPTION