User`s manual

P-660 Series Support Notes
99
All contents copyright © 2005 ZyXEL Communications Corporation.
Key Settings:
Class Name
Give this class a name, for example, 'App'
Bandwidth
Budget
Configure the speed you would like to allocate to this class
Priority
Enter a number between 0 and 7 to set the priority of this class. The higher the
number, the higher the priority. The default setting is 3.
Bandwidth
Borrowing
Check this box if you would like to let this class to borrow bandwidth from it's
parents when the required bandwidth is higher than the configured amount. Do
not check this if you want to limit the bandwidth of this class at the configured
value.(Please note that you should also disable Maximize Bandwidth Usage
on the interface to meat the condition.)
Enable
Bandwidth
Filter
Check this to specify the traffic types via IP addresses/Port numbers.
Destination
IP Address
Enter the IP address of destination that meats this class.
Destination
Subnet Mask
Enter the destination subnet mask.
Destination
Port
Enter the destination port number of the traffic.
Source IP
Address
Enter the IP address of source that meats this class. Note that for traffic from
'LAN to WAN', since BWM is before NAT, you should use the IP address
before NAT processing.
Source
Subnet Mask
Enter the destination subnet mask.
Source Port
Enter the source port number of the traffic.