User`s manual

P-660 Series Support Notes

• Enter the IP address of the PPTP server (WinNT server) and the port

number for PPTP as shown below.

When you have finished the above settings, you can ping to the remote Win9x client

from WinNT. This ping command is used to demonstrate that remote the Win9x can

be reached across the Internet. If the Internet connection between two LANs is

achievable, you can place a VPN call from the remote Win9x client.

For example: C:\ping 203.66.113.2

When a dial-up connection to ISP is established, a default gateway is assigned to the

router traffic through that connection. Therefore, the output below shows the default

gateway of the Win9x client after the dial-up connection has been established.

Before making a VPN connection from the Win9x client to the NT server, you need to

know the exact Internet IP address that the ISP assigns to P-660 router in SUA mode

and enter this IP address in the VPN dial-up dialog box. You can check this Internet

IP address from PNC Monitor or SMT Menu 24.1. If the Internet IP address is a fixed

IP address provided by ISP in SUA mode, then you can always use this IP address for

reaching the VPN server.

In the following example, the IP address '140.113.1.225' is dynamically assigned by

ISP. You must enter this IP address in the 'VPN Server' dialog box for reaching the

PPTP server. After the VPN link is established, you can start the network protocol

application such as IP, IPX and NetBEUI.

Menu 15.2.1 - NAT Server Setup (Used for SUA Only)

Rule Start Port No. End Port No. IP Address

---------------------------------------------------

1. Default Default 0.0.0.0

2. 1723 1723 192.168.1.10

3. 0 0 0.0.0.0

4. 0 0 0.0.0.0

5. 0 0 0.0.0.0

6. 0 0 0.0.0.0

7. 0 0 0.0.0.0

8. 0 0 0.0.0.0

9. 0 0 0.0.0.0

10. 0 0 0.0.0.0

11. 0 0 0.0.0.0

12. 0 0 0.0.0.0

Press ENTER to Confirm or ESC to Cancel: