User`s manual

P-660 Series Support Notes

address of the computer is assigned by the P-660. The P-660 can also provide the

DNS to the clients via DHCP if it is available. For this setup in Windows, we check

the option 'Obtain an IP address automatically' in its TCP/IP setup. Please see the

example shown below.

Set up your P-660

The following procedure shows you how to configure your P-660 as Router mode for

routing traffic. We will use SMT menu to guide you through the related menu. You

can use console or Telnet for finishing these configurations.

1. Configure P-660 as router mode in Menu 1 General Setup.

Menu 1– General Setup

System Name= P-660

Location=

Contact Person's Name=

Domain Name=

Edit Dynamic DNS= No

Route IP= Yes

Bridge= No

2. Configure a LAN IP for the P-660 and the DHCP settings in Menu 3.2-TCP/IP

Ethernet Setup. The settings except of the DNS addresses shown below are the pre-

configured defaults.