User`s manual

P-660 Series Support Notes
191
All contents copyright © 2005 ZyXEL Communications Corporation.
ip nat server disp [1]
?isp 1?means to display the NAT server
set in buffer, if parameter ?? is omitted,
then it will display all the server sets
Menu 15.2
ip nat server save Save the NAT server set buffer into flash
Menu 15.2
ip nat server clear [set#]
Clear the server set [set#], must
use ?ave?command to let it save into
flash
Menu 15.2
ip nat server edit [rule#] active
Activate the rule [rule#], rule number is 1
to 24, the number 25-36 is for UPNP
application
Menu 15.2
ip nat server edit [rule#] svrport
<start port> <end port>
Configure the port range from <start port
> to <end port>
Menu 15.2
ip nat server edit [rule#] remotehost
<start IP> <end IP>
Configure the IP address range of remote
host (Leave it to be default value if you
don? need this command)
Menu 15.2
ip nat server edit [rule#] leasetime
<seconds>
Configure the lease time (Leave it to be
default value if you don? want this
command)
Menu 15.2
ip nat server edit [rule#] rulename
<string>
Configure the name of the rule (Leave it
to be default value if you don? want this
command)
Menu 15.2
ip nat server edit [rule#] forwardip
<IP address>
Configure the LAN IP address to be
forwarded
Menu 15.2
ip nat server edit [rule#] protocol
<TCP|UDP|ALL>
Configure the protocol to be used TCP ,
UDP or ALL (it must be capital)
Menu 15.2
sys filter set index [set#] [rule#]
Set the index of filter set rule, you may
apply this command first before you
begin to configure the filter rules
Menu 21 filter
sets
sys filter set name [set name] Set the name of filter set
Menu 21 filter
sets
sys filter set type [tcpip | generic] Set the type of filter rule
Menu 21 filter
sets
sys filter set enable Enable the rule
Menu 21 filter
sets
sys filter set disable Disable the rule
Menu 21 filter
sets
sys filter set protocol [protocol #] Set the protocol ID of the rule
Menu 21 filter
sets
sys filter set sourceroute [yes|no] Set the sourceroute yes/no
Menu 21 filter
sets
sys filter set destip [address] [subnet
mask]
Set the destination IP address and subnet
mask of the rule
Menu 21 filter
sets
sys filter set destport [port#]
[compare type =
none|equal|notequal|less|greater]
Set the destination port and compare type
(compare type could be
0(none)|1(equal)|2(not
equal)|3(less)|4(greater) )
Menu 21 filter
sets
sys filter set srcip [address] [subnet
mask]
Set the source IP address and subnet
mask
Menu 21 filter
sets
sys filter set srcport [port#] [compare
type = none|equal|not
equal|less|greater]
Set the source port and compare type
(compare type could be
0(none)|1(equal)|2(not
equal)|3(less)|4(greater) )
Menu 21 filter
sets
sys filter set tcpEstab [yes|no] Set TCP establish option
sys filter set more [yes|no] Set the more option to yes/no
Menu 21 filter
sets
sys filter set log [type 0-3= none |
match| notmatch | both ]
Set the log type (it could be 0-3 =none,
match, not match, both)
Menu 21 filter
sets
sys filter set actmatch[type 0-2 =
checknext | forward | drop]
Set the action for match
Menu 21 filter
sets