User`s manual

P-660 Series Support Notes
190
All contents copyright © 2005 ZyXEL Communications Corporation.
[rip1|rip2b|rip2m]
wan node multicast
[none|igmpv1|igmpv2]
Set the wan IP multicast mode
Menu 11.3
wan node filter [incoming|outgoing]
[tcpip|generic]
[set #1] [set #2] [set #3] [set #4]
Set WAN filter, incoming or outgoing
can be specified, and filter set can be 1-
12, value 0 means empty
Menu 11.5
wan node save
Save the related parameters of WAN
node
wan node display
Display WAN profile configuration in
buffer
Display Menu
11
ip route addrom index [Rule #] Select a Static Route index 1-16 to edit
Menu 12.1
ip route addrom name [Name] Set Rule Name
Menu 12.1
ip route addrom active [on|off] Set Active or Inactive Flag
Menu 12.1
ip route addrom set [dest address/
mask bits] [gateway] [metric]
Set IP static route
Example:
> ip ro addrom set 192.168.1.33/24
192.168.1.1 2
Menu 12.1
ip route addrom private [yes|no] Set Private Flag
Menu 12.1
ip route addrom disp
Display both working buffer and Editing
Entry
Menu 12.1
ip route addrom freememory Discard all changes
Menu 12.1
ip route addrom save Save edited settings
Menu 12.1
ip route addrom clear [Index #] Clear Static Route Index
Menu 12.1
ip nat addrmap map [map#] [set
name]
Select NAT address mapping set and set
mapping set name, but set name is
optional
Example:
> ip nat addrmap map 1 myset
Menu 15.1
ip nat addrmap rule [rule#] [insert |
edit] [type] [local start IP] [local end
IP] [global start IP] [global end IP]
[server set #]
Set NAT address mapping rule. If
the ?ype?is not ?nside-server? then
the ?ype?field will still need a dummy
value like ??
Type is 0 - 4 = one-to-one, many-to-one,
many-to-many-overload, many-to-many-
non overload, inside-server
Example:
> ip nat addrmap rule 1 edit 3
192.168.1.10 192.168.1.20
192.168.10.56 192.168.1.56 0
Menu 15.1
ip nat addrmap clear [map#] [rule#] Clear the selected rule of the set
Menu 15.1
ip nat addrmap freememory Discard Changes
Menu 15.1
ip nat addrmap disp Display nat set information
Menu 15.1
ip nat addrmap save Save settings
Menu 15.1
ip nat server load [set#] Load the server sets of NAT into buffer
Menu 15.2